Lighting Oil

[mjohnson2981]

Hello,

I have modified a Becket AFG to run on waste oil.

Here is what I have done:

* Changed nozzle from the rated .85 to .55 same pattern & angel (70* Solid)
* Added PID, thermocouple, and cartridge heater clampled around J-tube inside barrel
* Filter oil through a 10 Micron hydraulic oil filter and throught a RF-1 filter
* Turned pump pressure up to 135psi
* Operate PID at about 350*F

What I have found:
   The unit lights and runs fine but I plug nozzles like crazy. I understand that  I should run the temperature around 170*F. This is fine, however I cannot get the unit to light at 170*F.

Is there a differnt adjustment other than factory for the electrodes or another trick?

Any help is appreciated.

[Russ]

You can turn up your heat to get it lit, but then turn the temp down.  Unfortunately this is a downside to a pressure type system.

I have also found that larger nozzles are easier to get started, but may put out too much heat.  Dont melt your furnace down!