Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - gte

Pages: [1]

Waste Motor Oil / Oil not igniting

« on: February 10, 2017, 11:32:02 pm »

I thought I had contaminated oil at first because I could not ignite it, but now I'm beginning to think my 30609-5 nozzle is partially clogged. If I remove the nozzle, I can ignite the oil. If I spray compressed air through the nozzle and clean it, it will ignite for 30 seconds and then clog up again.

Is it possible my nozzle went bad? Is this common?

I have a CleanBurn 2800 if that matters.

Waste Motor Oil / My cb2800 won't start ... thoughts or ideas?

« on: February 01, 2015, 01:05:33 pm »

My cb2800 will run for 5 seconds or so but it will not ignite. Does anyone have any ideas what to check for next? I have used motor oil in the tank, I'm seeing oil on nozzle when I pull the heater unit away from the combustion chamber but I'm not sure how to check the electrode? How can I check to see how the oil is spraying/atomizong? What else should I be looking at?

Below is a video of what it is doing.

http://youtu.be/9K9GrK3UR0E

User Projects & Pictures / Looking for help with a CB2800

« on: March 28, 2013, 11:48:08 am »

I have a CB2800 that I purchased but did not disassemble and I was wondering if anyone had one here they could offer advice on assembling and possibly pictures?

Thanks!