Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Revolution

Pages: [1]
1
Fuel Pre-Heaters / Re: What temp should oil be preheated to?
« on: November 25, 2011, 05:45:31 pm »
what temperatue should i set my temperature controller for nozzle block  to heat my wvo?

2
Temp Controllers and Thermocouples / Re: whick temperature controller?
« on: November 20, 2011, 01:55:34 pm »
haha thanks

3
Temp Controllers and Thermocouples / Re: whick temperature controller?
« on: November 20, 2011, 09:18:04 am »
guys will this controller work? http://www.ebay.com/itm/110761209223?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

i hope so cause i own it now

4
Welcome Center / Re: hello
« on: November 16, 2011, 04:31:21 pm »
and could somone give me measurment on your float tanks? how much oil they hold? im thinking about making an aluminum one

5
Waste Oil Filtering / filtering wvo?
« on: November 13, 2011, 08:28:27 am »
i was wondering what micron wvo should be filtered down to before going into the burner?

6
Welcome Center / hello
« on: November 11, 2011, 07:00:35 pm »
hi i am trying to convert my oil furnace into a wvo burner. i am getting a heater head from ckburner and was wondering what else ill need. i got a air pressure regulator. a fridge compressor. what else do i need and will the fridge compress be enough to keep up. do i have to put a tank on the compressor? what activates the compressor?
thanks

7
Temp Controllers and Thermocouples / Re: whick temperature controller?
« on: November 11, 2011, 06:57:57 pm »
ok so i would have to get a thermocoupler with that one. with the built in relay does it got other outputs for external relays? what all runs off the relay?

8
Temp Controllers and Thermocouples / whick temperature controller?
« on: November 11, 2011, 08:40:44 am »
hi i am in the process of gathering all the parts i need to convert my beckett in to a wvo burner. im looking at temperature controllers but cant figure out which one i need? do i need one with a built in relay or ssr relay output? what is a good one that will get the job done
thanks

Pages: [1]