Spiral/coil waste oil burner

[Michael]

Complete beginner here!

While googling I came across a design for burning waste oil. I did not save it and cannot find it again!

It used small gauge copper pipe twisted round a broom shaft then turned back so an oil jet (gravity only) was directed back through the centre of the spiral. The idea is that the flame preheats the oil and by the time it reaches the discharge point it ignites readily. Obviously this needs pre heating to get started. This could be done with butane/propane or wood fire etc

Obviously many of you will be fully aware of what I am trying to describe.

I look forward to replies.

Thanks

Mike

[Cmdr. Ron]

SHALOM!
Did you ever get an answer on that tight coil, Mike?  Your post date shows 19+ months since asking, with no response until now.  This has been on my screen several times the last month or so.

• http://www.green-trust.org/oil_burner.htm

Because it is GreenTrust, this is probably a spin-off, but the line drawing is clearer than i remember the photo's being.

Door knobs weren't designed for oily hands.