Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dc

Pages: [1]
1
Commercial Waste Oil Heaters / laniar waste oil burner
« on: February 02, 2014, 12:26:51 pm »
A freind of mine gave me a lanair waste oil motor burner assemblly. do you think I could extend the tube and keep a small
nozzle on it and use it in my furnace like you would like a ck burner kit. Also what I read the air pressure opens the fuel
valve to let the fuel in. Do you think it could be gravity flowed into instead of a pressure pump or not. thanks for any response I might get

2
Constant Level Device / why constant level device
« on: December 28, 2013, 10:13:37 pm »
The commercial units do not use one that I now of. But I could be wrong. In my pressure system I do not use one. I only
use a five gallon container to gravity feed my becket oil furnance that I run waste oil through at 25% diesel and 75% waste oil mix.

3
Siphon Nozzle / reznor style nozzle used in beckett burner
« on: December 25, 2013, 09:59:41 pm »
Has someone used reznor ra/rad parts to make a siphon nozzle. The basic set up is like a beckett pressure nozzle but the front is converted to a siphon nozzle. The parts are available from outher sources as well as reznor. Also I have seen
from pattriot supplly and ebay universal nozzle adapters.

I currentlly use a stock beckett burner pressure nozzle set up and mix my waste oil with 25% diesel . looking to go pure waste oil and change my nozzle

Pages: [1]