Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - WoodsBM1207

Pages: [1]
1
Temp Controllers and Thermocouples / Re: Can you use a Ranco temp controller?
« on: February 23, 2012, 12:23:58 pm »
Exactly.  I think I'll give it a try.  It doesn't seem to be too complicated.  It might be a couple of weeks before I get to that point, but I will report back and let you know the outcome.  Thanks for your reply. 

2
Temp Controllers and Thermocouples / Can you use a Ranco temp controller?
« on: February 21, 2012, 08:24:53 pm »
Just wondering if it is possible to use a Ranco temp controller to control the pre-heater cartridge.  Or would just be easier to use a PID?  I am still in the gathering parts stage, exploring other ways to achieve the same result.  I will be burning WMO and waste synthetic rotary screw compressor oil using a beckett burner/weil mclain boiler.  All replies will be greatly appreciated. 

Here is the link for the Ranco Controller:  http://www.etcsupply.com/ranco-etc111000000-digital-temperature-controller-p-86.html   ** It may not be this exact model, but something similar. 

Pages: [1]