Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - robjohn

Pages: [1]
1
Welcome Center / Re: LOW FUEL SWITCH
« on: January 11, 2016, 10:33:04 pm »
I found a source for the switch, it is the Madison company.  I got one custom made that kills the thermostat signal at the low level and completes the circuit to the transfer shut off valve when tank is full.  Was pleasantly surprised at the reasonable price.

2
Siphon Nozzle / Synthetic oil in energy logic
« on: January 11, 2016, 01:10:53 am »
I have an energy logic 200 that does a good job except for a couple things.  My oil supply gets some synthetic.  If My intake happens to pick up a gob that hasn't gotten blended the fire goes out.  Does anyone know what EL's minor modification consists of?  They won't talk to me because I bought the burner used.  I added a filter heater that seems to help some.  Trouble usually starts after transferring cold oil from outside storage to feed tank.  Burner is on a  chamber that is designed to burn wood so when it does this WE load it with wood, get a good hot fire going and run in pump prime mode till the problem oil is cycled through.  But that means a person has to waste a bunch of time.   Any ideas?       
Thanks

3
Welcome Center / LOW FUEL SWITCH
« on: May 03, 2012, 07:38:29 am »
I am running an Energy logic burner in a home built boiler using a Diesel tank from an 18 wheeler for fuel feed.  I would like to rig a low fuel cut off inline with the thermostat.  The tank has the usual opening for a swing arm fuel gauge.  Anyone know where I can get a simple vertical float switch that will open the circuit when the oil gets low?
Thanks

4
Welcome Center / ENERGY LOGIC
« on: February 16, 2010, 02:03:11 pm »
I need a wiring diagram for energy logic.  Anyone have one to share.
Thanks

Pages: [1]