Waste Oil Heater > Welcome Center

Clean burn won't light

(1/7) > >>

dannyo:
I have a Cleanburn 1400. It has oil supply but no fire. I have changed the ignitor, checked electrodes. Done anyone have any advice?

ShopSpecialties:
Oil quality ?

Clean nozzle ?

Spark is good shooting past the nozzle ?

dannyo:
Oil is good / nozzle is clean.
No spark what so ever.
I have cleaned how the oil laying in the bottom.
Do you know if there is thread or check list to go over the electric?
As I said I replaced the ignitor, electrodes look good, contact points on the ignitor are clean.
Is there sensor that detects excessive oil or mist?

ShopSpecialties:
Ok lets take it slow and simple.

No spark ? The easy way to check for spark is to lift the ignitor slowly while it is trying to fire to see if spark jumps to the electrodes.

Does the blue wire from the ignitor go to #7 on the wiring block or do you have an updated primary control to where 2 blue wires are wire nut together ?

dannyo:
The blue wire is 7 and white is 1.

Navigation

[0] Message Index

[#] Next page