Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gte

Pages: 1 2 3 [4]
46
Waste Motor Oil / Re: My cb2800 won't start ... thoughts or ideas?
« on: February 08, 2015, 10:29:12 pm »
Strangely enough, I did the test procedure you advised (thank you for that) and I saw spark so I set the contacts back down on the electrodes and she fired up and has been starting on her own ever since?

My only other bug to work out now is that the fan runs constantly, even when I change the position of the white plastic piece from auto to manual or manual to auto.

47
Waste Motor Oil / Re: My cb2800 won't start ... thoughts or ideas?
« on: February 01, 2015, 04:39:15 pm »
I will try to do that when I'm back out there tomorrow. I don't know if the way it is setup, I can do that but I will try that next to try and narrow this down.

48
Waste Motor Oil / Re: My cb2800 won't start ... thoughts or ideas?
« on: February 01, 2015, 04:20:43 pm »
Hi,

I stuck a paper towel that was lit and the oil ignited.  The electrical unit is also sending 120vac to the contacts and the electrode insulator has ~0ohms of resistance.

Could the electrodes be bad?

49
Waste Motor Oil / My cb2800 won't start ... thoughts or ideas?
« on: February 01, 2015, 01:05:33 pm »
My cb2800 will run for 5 seconds or so but it will not ignite. Does anyone have any ideas what to check for next? I have used motor oil in the tank, I'm seeing oil on nozzle when I pull the heater unit away from the combustion chamber but I'm not sure how to check the electrode? How can I check to see how the oil is spraying/atomizong? What else should I be looking at?

Below is a video of what it is doing.

http://youtu.be/9K9GrK3UR0E

50
User Projects & Pictures / Re: Looking for help with a CB2800
« on: March 29, 2013, 07:13:58 am »
Hi Doug,

Thanks. Is there also an installation manual as well? I see this has installation instructions in it but was wondering if there was a separate installation manual?


Quote from: doug on March 28, 2013, 07:26:43 pm
Here's a manual I hope it helps you.
http://www.cleanburn.com/products/manuals/CB-1400_1800_2800%20BOOK.pdf

51
User Projects & Pictures / Looking for help with a CB2800
« on: March 28, 2013, 11:48:08 am »
I have a CB2800 that I purchased but did not disassemble and I was wondering if anyone had one here they could offer advice on assembling and possibly pictures?

Thanks!

Pages: 1 2 3 [4]