Waste Oil Heater Forum - Your definitive source for burning waste oil for heat.
Waste Oil Heater => User Projects & Pictures => Topic started by: Dead Eye on December 19, 2010, 09:38:18 pm
-
Well here is the start on the lil gun. A conversion to a Wayne burner using a Craig Kepner (ckburner) kit.
The first mod is to extend the air tube (blast tube) to hold the preheater and a hole in it for the fuel line.
(http://www.deadeyestudio.com/tube.JPG)
A Kagi retention head.
(http://www.deadeyestudio.com/kagi.JPG)
A spring added to top of preheater block to hold center
(http://www.deadeyestudio.com/spring.JPG)
The PID temp control to left side
(http://www.deadeyestudio.com/pid.JPG)
-
Lookin good. Keep up the good work!
-
Started the Combustion Chamber~ Built of 10 inch pipe inside a water tank.
No pics yet but a drawing I made.
(http://www.deadeyestudio.com/heatercad.jpg)
-
Started construction of the combustion chamber, It is a piece of 10” pipe with ¼ wall thickness 4.5 feet long. The burner end has a mount ring tack welded to it 10.5” diameter with a 4 ¼” hole for the burner air tube (blast tube) other end has a flange with blank off plate for cleaning out.
First try yielded a nice looking flame burning old soy bean oil but after shut down it was found that the inside wall off the pipe was wet with oil so I will construct a smaller inside pipe (burn tube) to hold the pattern together.
-
Getting it together
(http://www.deadeyestudio.com/DPP_0002.JPG)
(http://www.deadeyestudio.com/DPP_0003.JPG)
(http://www.deadeyestudio.com/DPP_0004.JPG)
(http://www.deadeyestudio.com/DPP_0005.JPG)
(http://www.deadeyestudio.com/DPP_0006.JPG)
I build this way for easy clean out.
-
Very interesting. Cant wait to see how it works out for you. Lots of custom stuff out here, but mostly drip style. Thanks for sharing!
-
Burned a half quart of WVO in it today and it has the dreaded wet chamber. Will make a burn tube soon.
-
Hi Dead Eye
do you have any pics of the nozzel your using, im kinda lost how this sypon system works, or is there any detailed pic on this website Thanks Steve
-
Hey Steve, sorry for the oh so late reply Iv not been on here for a few weeks. There are a few pics at the top of this thread. Its the brass piece screwed into the block. You can google delavan siphon nozzle or hago siphon nozzle to see the other end. It has a stem with o ring on it.
-
Thanks Dead Eye, i ordered a pre heater block and nozzel from ck burners,also a pid and retension head, how did you make out with yours is it up and running now ?