16
Welcome Center / Re: Clean burn won't light
« on: December 24, 2020, 12:35:01 pm »
I'll try that next.
Which wire should be hot?
Which wire should be hot?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
17
Welcome Center / Re: Clean burn won't light
« on: December 24, 2020, 10:49:38 am »
The blue wire is 7 and white is 1.
18
Welcome Center / Re: Clean burn won't light
« on: December 23, 2020, 11:40:27 am »
Oil is good / nozzle is clean.
No spark what so ever.
I have cleaned how the oil laying in the bottom.
Do you know if there is thread or check list to go over the electric?
As I said I replaced the ignitor, electrodes look good, contact points on the ignitor are clean.
Is there sensor that detects excessive oil or mist?
No spark what so ever.
I have cleaned how the oil laying in the bottom.
Do you know if there is thread or check list to go over the electric?
As I said I replaced the ignitor, electrodes look good, contact points on the ignitor are clean.
Is there sensor that detects excessive oil or mist?
19
Welcome Center / Clean burn won't light
« on: December 23, 2020, 08:21:20 am »
I have a Cleanburn 1400. It has oil supply but no fire. I have changed the ignitor, checked electrodes. Done anyone have any advice?
Pages: 1 [2]