Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - robjohn

Pages: [1]
1
Siphon Nozzle / Synthetic oil in energy logic
« on: January 11, 2016, 01:10:53 am »
I have an energy logic 200 that does a good job except for a couple things.  My oil supply gets some synthetic.  If My intake happens to pick up a gob that hasn't gotten blended the fire goes out.  Does anyone know what EL's minor modification consists of?  They won't talk to me because I bought the burner used.  I added a filter heater that seems to help some.  Trouble usually starts after transferring cold oil from outside storage to feed tank.  Burner is on a  chamber that is designed to burn wood so when it does this WE load it with wood, get a good hot fire going and run in pump prime mode till the problem oil is cycled through.  But that means a person has to waste a bunch of time.   Any ideas?       
Thanks

2
Welcome Center / LOW FUEL SWITCH
« on: May 03, 2012, 07:38:29 am »
I am running an Energy logic burner in a home built boiler using a Diesel tank from an 18 wheeler for fuel feed.  I would like to rig a low fuel cut off inline with the thermostat.  The tank has the usual opening for a swing arm fuel gauge.  Anyone know where I can get a simple vertical float switch that will open the circuit when the oil gets low?
Thanks

3
Welcome Center / ENERGY LOGIC
« on: February 16, 2010, 02:03:11 pm »
I need a wiring diagram for energy logic.  Anyone have one to share.
Thanks

Pages: [1]