Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - GerryADS

Pages: [1]
1
Waste Motor Oil / Siphon Nozzle Flow Changes?
« on: January 18, 2024, 07:26:41 am »
Hey Folks,

I've been running a Delavan 30609-9 (SNA.85) for a few years, and have generally ironed out most of the bugs in my system, however recently I have found that the quantity of oil consumed has drastically reduced for the same air pressure. I've had it apart a good few times over the years, to clean and replace the seal, however the main system remains the same, in that my pre-heat tank sit at 99C via PID, my siphon height is the same 30mm below the nozzle orifice (control keeps level to within 5mm) and my nozzle PID heater holds 75C. Previously I would consume approx. 3.7 Litres per hour at 5psi air pressure, but now I'm down to about half of that? I've checked everything for leaks, replaced all the fittings and pipe work, and new viton seal, all fittings are clean, and there has been no physical changes, but it would appear I've lost vacuum from the siphon effect?
Does the nozzle wear (there is nothing visual, but I don't have another to compare - yet) my oil is filtered to better than 100 microns, but this nozzle has probably seen 12000 Litres use, anybody else experience similar?


2
Waste Motor Oil / Oil Suitability - Testing?
« on: June 03, 2022, 07:09:50 am »
Hey Folks,

Fairly new in here from Scotland  :D

Have been running a kerosene burner which I converted to WMO using a siphon nozzle & fitted with a DELAVAN 30609-9 - 0.85GPH(US).

It has PID controlled Nozzle heater, and PID controlled feed tank, the first year, I guess I got lucky with the oil I received & filter technique, but lately it can be hit or miss with regards the suitability of the oil.

Firstly the oil is allowed to stand for a few months (inside) and the settled water is drained, oil is then pumped to a higher tank and a slow gravity feed passes through several strainers, before entering a Racor/Parker RFF Water Separating Fuel Filter Funnel.

However the last few batches of oil (unknown) seemed to have been difficult to ignite or keep lit, I've checked over all the burner side of things, and all is well (proof tested with known good WMO & works fine) I suspected emulsified/suspended water, but even if I turn the PID heater up in the feed tank (where the siphon is fed from) then whilst I can sometimes witness water boiling off, eventually settling down to a very hot (160C) without any steam coming out, it still proves difficult, I have found that I then have to turn the PID nozzle temperature way up, but even with that, it will sometimes fail to stay lit as soon as the ignition spark is cut. The only way I have found to keep the difficult oil lit after ignition is off is to run the nozzle with almost 2.5X the air pressure, however that is far too much heat for the small size of combustion chamber (water jacket heating boiler/furnace)

Therefore my question (after the long-winded intro) is what are you guys using to prove/test the suitability of the WMO, so as to not go through the pain of all the preparation of a less than ideal WMO?

I have some ISO32 Hydraulic oil which I though should burn easier than WMO from an auto shop, but found it needed a reasonable amount more tank & nozzle heat, is this to be expected?

What temperatures do you all use at the nozzle and tanks with what oils please?

Thanks for listening  :)

Gerry

Pages: [1]