Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - OILHEAT

Pages: [1]
1
Drip System / OZZERT burner rules
« on: February 23, 2012, 10:21:51 pm »
Been a full winter and the garage was always warm when I needed it to be from the ozzert design oil stove.

All I could see from the chimney was some heat vapors, nothing elts. On the other end of the chimney was a hot, heat throw'n stove keeping me warm as I worked on different projects.

Watch the you tube vids, pay attention to ozzerts burn chamber 's' and build one just like that and it WILL make a lot of cheap heat.

THANK YOU OZZERT!!!

2
Welcome Center / Hello everybody, I too built a Sanders style oil burn'n stove a year ago.....
« on: November 27, 2010, 12:08:22 pm »
After seeing how other shops/garage heated with waste oil, I did some research and found that Rodger Sanders gravity feed, vaporization system design seemed to be the best in simplicity. No electric fans, no compressed air, no carbon/ coal, soot caked-up hard to clean burn chamber and components. I decided to build one and gained room and heat in the garage by eliminating the wood pile in the corner, oil stores Way better and removing the bulky wood burning stove. Found out right away, there is lots more btu's in oil than wood too.                                                                                                               
  Like Russ, I found that an oversized steel burner/vaporizer cone was best. I was looking to improve/change different points of the stove and have found a CORNUCOPIA of information on this forum about burning this" black gold" and not to mention on the sanders design of burner. I hope I can be of assistance for members and gather some good info from members! I will try and post pics after I figger out everything here..... 

Pages: [1]