Waste Oil Heater Forum - Your definitive source for burning waste oil for heat.

Waste Oil Heater => Commercial Waste Oil Heaters => Topic started by: Blazin on February 21, 2020, 05:39:26 pm

Title: Lanair MX250 fuel PSI
Post by: Blazin on February 21, 2020, 05:39:26 pm

Lately I've had to run my fuel pressure up around 8/10 lbs. Furnace runs but tends to not fire without manual reset most of the time, then it tends to short cycle. Fire several times, then the blower finally comes in. Some times it will go all day, or night. Sometimes it goes one, or two cycles. Anyone have a nay tips?

Title: Re: Lanair MX250 fuel PSI
Post by: ShopSpecialties on February 22, 2020, 09:19:52 pm

When was the last time a burner rebuild was done ?